these is how im making my wooden cages.
im still in the process and thought sharing would help inspire someone else.
These will be 42inch x 15inch x 15inch each and the whole thing is 63inch hight.
they will have a divider in the middle and each cage will have 4doors and 8small food cup doors in the fron. One of the sides will have 2 doors, one for breeding boxes and a door.
Only the front and the left side will be with wires. The back and right side will be closed with mdf.
How i started is by ripping the wood with the table saw. the individual pieces are 1/2inch x 1/2ich and the side and back bottoms are 1 1/2ich x 1/2inch.
i used my drill press for drilling the whole pieces and i'll be using electric fencing wire.
Its a long process i know but i like making stuff and being a hobbies that gives me more motion.
here is where im at right now.
everything is put together using glue and nails.
i drilled the pieces together then used nails to hold it BUT i got sick of it pretty soon so i went and bought a pin nailer. Best decision for this project. It doesnt need too much support on individual pieces because the whole thing is going to support itself together pretty good.
I have done these cages in the past and when the whole thing comes together is pretty strong.
Im thinking of painting the whole thing yellow or blue.
This cage is going to be hopefully a breeder for my gouldians, canaries and goldfinches.
thanks Elana. 
