manzanita perch ?

For questions about finch enclosures (cages & aviaries).
Post Reply
ac12
Molting
Molting
Posts: 6421
Joined: Mon Feb 23, 2009 9:39 pm
Location: California, SF Bay Area

manzanita perch ?

Post by ac12 » Mon Apr 20, 2009 4:50 pm

I was watching my finches, and it seems that the manzanita perch is too smooth.
- They seem to have a difficult time getting a good grasp on it. Their nails can't dig into anything since the surface is hard and smooth.
- Sometimes they land on the branch with their momentum causing them to almost rotate around the perch, doing a 180 like a gymnast on a high bar.
- Because the manzanita surface is hard and smooth, will this let their nails grow, rather than wearing it down.

On the plus side, the smooth surface makes it easy to clean.

My other perch is a maple branch that has a rough surface, and that is the lower perch on the opposite side of the cage.
Gary

gouldians (GB,YB,BB), blackbelly firefinches (trying to breed), societies (foster parents).
red factor canary

User avatar
B CAMP
Molting
Molting
Posts: 3012
Joined: Wed Dec 19, 2007 10:11 pm
Location: CLEARWATER,FL

Post by B CAMP » Mon Apr 20, 2009 6:23 pm

The natural perches are the best I think for that reason.Try to have different diameters and these are free :)
Bill

User avatar
hilljack13
Jute Junkie
Jute Junkie
Posts: 524
Joined: Sat Jan 26, 2008 11:05 pm
Location: Fort Walton Beach, FL

Post by hilljack13 » Tue Apr 21, 2009 7:48 pm

I use both natural and manzanita perches. I have ones that are about half inch at the screw to about 1/4 at the end. It is funny sometimes to see them slide down one part of the perch. There is no need to worry about their nails if they have other ways of keeping them trimmed like gravel paper for the bottom. I like to use the wire bottoms in my cage so I just cut a piece of gravel paper for them to use.

ac12
Molting
Molting
Posts: 6421
Joined: Mon Feb 23, 2009 9:39 pm
Location: California, SF Bay Area

Post by ac12 » Wed Apr 22, 2009 12:27 am

hilljack
You mean the finches know to use the gravel paper to wear down their nails?
Gary

gouldians (GB,YB,BB), blackbelly firefinches (trying to breed), societies (foster parents).
red factor canary

User avatar
franny
Weaning
Weaning
Posts: 1631
Joined: Fri Jul 25, 2008 5:19 pm
Location: Winnipeg, MB. Canada
Contact:

Post by franny » Thu Apr 23, 2009 9:05 pm

I don't think the gravel paper is so good, personally. They will avoid hopping around on the bottom of the cage as it is also hard on their feet in my opinion. Can you replace your manzinita perch with a cement perch?
Fran

-----------------------
1 cat (Lexy) and hopefully soon another pair of Gouldians
My Website: https://www.localcolourart.com/meet-the ... 6b2f58a839

ac12
Molting
Molting
Posts: 6421
Joined: Mon Feb 23, 2009 9:39 pm
Location: California, SF Bay Area

Post by ac12 » Thu Apr 23, 2009 11:20 pm

Fran
Not in my current setup.
The manazinta is going front to back in front of the nest.
The front has wire mesh, but the back is a solid piece of coroplast, not wire.
I have to look for how I might put a sand perch in that cage. Unlike the stiff wire on a wire bird cage, the wire mesh is not stiff, it flexes somewhat easily. A perch on the wire mesh has to be supported on both ends.
Or maybe just replace the manzanita perch with a larger diameter perch with a rough surface.
Gary

gouldians (GB,YB,BB), blackbelly firefinches (trying to breed), societies (foster parents).
red factor canary

User avatar
atarasi
Weaning
Weaning
Posts: 1643
Joined: Mon Mar 24, 2008 5:50 pm
Location: Washington state, USA

Post by atarasi » Fri Apr 24, 2009 6:34 pm

I've noticed this too. Since Gouldians are private and usually breed in the nest, having slippery perches isn't an issue of them needing a tight grip. On the other hand, for other species that just breed out in the open, it's important that the hen can get a tight grip on the perch.
I'm going to sand down the tops of my manzanita perches not just for grippage, but for comfort.
Jordan

ac12
Molting
Molting
Posts: 6421
Joined: Mon Feb 23, 2009 9:39 pm
Location: California, SF Bay Area

Post by ac12 » Fri Apr 24, 2009 6:59 pm

What I like about the manzanita is the slick surface is easy to clean, just wipe with a damp paper towel.

Wood dowels I sand w #50, #100, and #150 (depending on how bad the poop is) to clean the poop off. The finer sandpaper is primarily to get rid of any splinters from the #50 sandpaper.

Natural branches....I dunno how to clean them.
Just with a plastic bristle brush and water?
Gary

gouldians (GB,YB,BB), blackbelly firefinches (trying to breed), societies (foster parents).
red factor canary

User avatar
B CAMP
Molting
Molting
Posts: 3012
Joined: Wed Dec 19, 2007 10:11 pm
Location: CLEARWATER,FL

Post by B CAMP » Fri Apr 24, 2009 8:49 pm

If they get to hard to clean the natural branchs just throw away and put in new ones there free :wink:
Bill

ac12
Molting
Molting
Posts: 6421
Joined: Mon Feb 23, 2009 9:39 pm
Location: California, SF Bay Area

Post by ac12 » Sat Apr 25, 2009 12:06 am

Anyone know if California Live Oak is OK for birds?
I've seen conflicting comments about Oak being OK or not.
I have 2 oaks in the yard, so I can get the larger branches.
My maple only gave me smaller branches when I pruned it.
Gary

gouldians (GB,YB,BB), blackbelly firefinches (trying to breed), societies (foster parents).
red factor canary

User avatar
B CAMP
Molting
Molting
Posts: 3012
Joined: Wed Dec 19, 2007 10:11 pm
Location: CLEARWATER,FL

Post by B CAMP » Sat Apr 25, 2009 9:13 am

Bill

darrell

Post by darrell » Sat Apr 25, 2009 10:53 am

All I use are white oak branches.A wire brush cleans them easily.

Post Reply